Press "Power" to turn off if the printer does not turn off, press it again.Ĭlose the cover and release the "Power" button.ĭownload and install GeneralTool software.
The green lights flash for a moment and then remain steady. Press "Resume" twice and release the two buttons. Leave "Power" pressed and release "Resume". Press on "Resume" then, without releasing, on "Power". Open the printer configuration software and select the USB port.Ĭhoose "Set detination 1" and reset to 1 must be done. Press "resume" once again and the light is green. Press once on "resume", the light turns orange. Press and hold the "Power" button and turn the printer back on. Turn off the printer and disconnect the usb cable. Press the button again for two seconds and release it. Press the button again within 5 seconds and release it. Press the "Resume / reset" button and at the same time reconnect the cable. Release everything and wait until the green light stops flashing: the printer enters "service mode". Release the "resume" button, then press twice on the same button, still holding the "power" button. Press and hold the "resume" button, then do the same with the "power" button. The "resume" button is a circle with an inner triangle pointing down: Note: The ink pad also physically exists in the printer under the print head, and there is a high probability that this pad is saturated with ink.Īlso, the printer is not waterproof, we advise you not to put it on a piece of furniture which could be damaged by ink running under the printer. The solution consists in carrying out a manipulation to reset this used ink counter to zero.ĭepending on your printer, there are different ways to reset the used ink counter. This, even if the printer worked well and printed correctly just before the message appeared. In this case, the manufacturer limits the life of the printer with a maximum number of pages to print. If the following message appears, "End of life items or components, contact Canon Support" or "Waste ink tank is almost full or full". Or install another cartridge if it is not recognized. Solution: remove the cartridge, then put it back. Meaning: the tank cartridge is not correctly installed. Solution: check that the hood is properly closed, that there is no gap or play, even slight. Contact your local Cartridge World store for a quote. 🖨 Canon Pixma IP3000 Inkjet Cartridges '}įunction addLoadEvent(e)ĮlById("notify"+r)&(y=elById("notify"+r),y.innerHTML=""),o.After reinstalling the print head and cartridges, if the fault persists, the only solution is to change the print head or change the printer.Īs an indication, the value of a Canon inkjet printhead is around £65 ex vat.
0 kommentar(er)
